Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ALUMINUM MODELS ONLY:
A. Using a tape measure double check the height of the ceiling.
B. Determine the location to cut the ladder and ladder feet for your ceiling height from table 3.
CEILING HEIGHT
7' 7" – 7' 8"*
7' 9" – 7' 10"
7' 11" – 8' 2"
8' 3" – 8' 5"
8' 7" – 9' 1"
9' 2" – 9' 3"
9' 4" – 9' 9"
9' 10" – 10' 3"
C. Cut the side rails and ladder feet (when required) at the appropriate line.
NOTE: The rail is not pre-marked for angle cuts required below a step (see Figure 9).
D. Press down on the climbing section to ensure that the folding arms are fully extended.
7
RAIL CUT
Figure 9, step #3
8' 6"
Figure 9, step #2
Figure 9, step #1
no cut
TABLE 3
Bottom section side rail
STEP 3:
Cut not marked
on rail
FOOT CUT
E
C
E
C
D
C
no cut
no cut
B
no cut
A
no cut
no cut
no cut
STEP 2:
Cut not marked
on rail
C
Aluminum feet
D
E
FIGURE 9
*7' 7" to 7' 8" ceiling
heights require
drilling mounting
holes. Use foot as
drilling template.
STEP 1:
Cut not marked
on rail
B
A
Publicidad
Tabla de contenido
