Technical Data; Noise Information; Vibration Information - Worx Sonicrafter WX679 Manual De Usuario

TECHNICAL DATA

Type designation: WX679 WX679.2 WX679.11 (6-designation of machinery, representative of
sonicrafter)
Rated voltage
Rated power
Oscillations speed
Protection class
Tool weight (without power cable)

NOISE INFORMATION

A weighted sound pressure:
A weighted sound power:
K &K :
pA wA
Wear ear protection when sound pressure is over:

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 60745:
Typical weighted vibration
– The declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another;
– The declared vibration total value may also be used in a preliminary assessment of exposure.
WARNING: The vibration emission value during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used dependant on the
following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or sanded.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately
managed
WARNING: To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool
is switched off and when it is running idle but not actually doing the job. This may significantly
Oscillating Tool
Vibration emission value a
Uncertainty K = 1.5m/s²
230-240V~50Hz
250W
12000-21000/min
/ll
1.3kg
84dB(A)
95dB(A)
3.0dB(A)
80dB(A)
= 3.32m/s
2
h
EN
7