Controls - GE AEL06 Manual Del Propietario Y Instrucciones De Instalación

Controls

Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Light indicates the unit is in the
temperature or delay time Set mode.
8
NOTE: The display always shows the room
temperature except when setting the Set
temperature or the Delay timer.
Air Conditioner Controls
Controls
Power Pad
1.
Turns air conditioner on and off. When turned on, the
display will show the room temperature.
Display
2.
Shows the room temperature or time remaining on
the Delay timer. Shows the Set temperature while
setting the temperature in Cool or Energy Saver
modes. The Set light will turn on while setting.
3.
Saver mode. The Set light will turn on while setting.
4.
Pads
Each touch of the
on the unit or the
the remote control will set the delay time when using
the timer. The Set light will turn on
while setting.
Fan Speed Pads
5.
on the unit. NOTE: On the remote control, use the
fan speed
fan speeds to Low, Med or High
to turn Auto fan on.
Mode Pad
6.
or Fan Only mode.
Note: The default temperature reading on the display is degree Fahrenheit ( °F). To change the display to degree Celcius (°C),
press the Temp Increase
to degree Fahrenheit (°F)
49-7793
Set
Temp / Delay
+
-
Filter Delay
Check 1-24 Hrs
Auto
Cool
High
Fan Only
Med
Energy Saver
Low
Fan
Mode
Speed
Power
Cool or Energy
pads
pads on
Low, Med, High or Auto
pads to set the
Auto pad
and Temp Decrease buttons together and hold for 3 seconds. Repeat the process to change back
Light indicates the
delay timer is set.
Delay
1–24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
set Increase
and
Decrease
Delay Pads/Delay 1-24hr Pad
7.
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can be
set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the
Delay pad on the remote control. Each touch of the
will set the timer in 1-hour intervals. The Set light will
turn on while setting.
To review the remaining time on the
timer, press the
pads on the remote control to set a new
time if desired.
To cancel the timer, press the
the light on the
Reset Filter
8.
LED will turn on when fan has accumulated 250
hours of run time as a reminder to clean filter.
Press Reset Filter to turn off the LED and reset the
accumulated run time.
Fan Fan
Remote Control
pads on the unit or the
pads on the remote control
pad on the unit or the
Increase
pads on the unit or the
pad goes off.
Delay
timer
Increase
Auto Fan
on
Fan
speed
Increase
Unit
power
on/off
pad until
5