Kenwood DPX-7200DAB Manual De Instrucciones página 14

Installing the DAB antenna
Connect the supplied DAB antenna to the DAB antenna jack. (Page 3)
CAUTION
• The film antenna (E) is exclusively for use inside the vehicle.
• Do not install at the following locations:
– where it may block the driver's view.
– where it may obstruct the operation of safety devices such as air bags.
– on movable glass surfaces such as the rear hatch.
– at side of vehicle (e.g. door, front quarter window).
– on rear window.
• Signal strength will weaken when installed at the following locations:
– on IR reflecting glass or locations covered with mirror type glass film.
– where it overlaps with genuine radio antenna (pattern).
– where it overlaps with window heating wires.
– on glass that blocks radio signals (e.g. IR reflecting glass, thermal
insulation glass).
• Poor reception may occur:
– due to noise when windscreen wiper, air conditioner, or motor is turned
on.
– depending on the direction of the broadcast station with respect to the
vehicle (antenna).
• Thoroughly wipe oil and dirt from the pasting surface with the supplied
cleaner (H).
• Do not bend or damage the film antenna (E).
• It may not be possible to install on certain vehicles.
• Check the cable routing of the film antenna (E) and amplifier unit (F)
before pasting.
• Do not apply any glass cleaner after pasting the film antenna (E).
4
Part list (supplied)
(E) Film antenna (×1)
(F) Amplifier unit (cable with booster, 3.5 m) (×1)
(G) Cable clamper (×3)
(H) Cleaner (×1)
Determine the antenna installation position
• The direction of the film antenna (E) changes depending on whether
the film antenna (E) is installed on the right side or left side.
• Be sure to check the installation location of film antenna (E) before
installing. Film antenna cannot be re-pasted.
• Separate from other antennas by at least 100 mm.
• Do not paste the amplifier unit (F) on the ceramic line (black part)
around the front glass. Because there is not enough adhesion.
Installing the antenna on the left side
Ceramic line (black part)
Earth sheet*
* Paste the earth sheet of the amplifier unit (F) on the metal part of the
front pillar.
Installing the antenna on the right side
Earth sheet*