Installation And Connection - Pontec PondoCompact 2000 Instrucciones De Uso

Installation and connection

Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries due to operation of this unit in a swimming pond.
Protective measures:
• Do NOT use this unit in a swimming pond.
• Adhere to national and regional regulations.
Operation under water
How to proceed: 4.
0.
B
1. Fasten the suction cups to the pump.
2. Screw the hose connector with O ring onto the outlet and hand tighten.
3. Set the flow rate (pump delivery rate).
− The regulator for setting the flow rate is located at the back of the filter housing.
− Turning the regulator clockwise: Increases the flow rate.
− Turning the regulator counterclockwise: Decreases the flow rate.
4. Fit the hose to the hose connector and install the pump underwater on a firm surface in a horizontal position.
− The pump can be fixed to a smooth, clean surface with the suction cups.
Operation out of the water
• Do not expose the unit to direct sunlight.
How to proceed:
5.
0.
C
1. Remove the filter housing.
− The filter housing is not required for operation out of the water.
2. Fasten the suction cups to the pump.
3. Screw the hose connector with O ring onto the outlet and hand tighten.
4. Screw the hose connector with flat seal and union nut onto the outlet and hand tighten.
5. Set the flow rate (pump delivery rate).
− Turning the regulator clockwise: Increases the flow rate.
− Turning the regulator counterclockwise: Decreases the flow rate.
6. Fit one hose to the hose connector at the inlet and one to the hose connector at the outlet, and install the pump on a
firm surface in a horizontal position.
− To prevent air from being taken in, ensure that the pump and the hose to the inlet always remain below the water
level.
− The pump can be fixed to a smooth, clean surface with the suction cups.
Start-up
Attention! Risk of injury due to unexpected start-up.
The temperature monitor switches the unit off automatically in the event of overload. The unit is switched on
again automatically as soon as it has cooled down.
Possible consequences: Risk of injury due to fast rotating components.
Protective measures: Always isolate the unit (switch off and disconnect from the power supply) before
starting any work on the unit.
NEVER allow the pump to run dry!
Possible consequences: The pump will be destroyed.
Protective measures:
• Ensure that the pump is always fully submerged in the water.
• Regularly check the water level.
• Switching on: Insert the power plug into the socket.
− The unit switches on immediately.
• Switching off: Disconnect the power plug.
37818-02-14_GA_PondoCompact_200011 11
- GB -
12.02.2014 14:37:15
11