Important Safety Information; Installation Instructions - Danby Sunbeam DFF258BLSSB Guía A Utilizar Y A Cuidar Del Proprietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INFORMATION

ELECTRICAL
REQUIREMENTS
This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly
installed and grounded.
IMPORTANT WARNING
An empty refrigerator can pose a threat to children.
To render the unit harmless we strongly recommend
removing the door prior to disposal.
Remove exterior and interior packings, wipe the
outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth. Avoid placing the
cabinet in a narrow recess or near any heat source,
direct sunlight, or moisture. Let air circulate freely
around the cabinet. Keep the rear of the freezer 5
inches away from the wall.
Location
1) Select a place with a strong, level floor.
2) Allow 5 inches of space between the back of the
freezer and any adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight
may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
This appliance must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electrical shock by providing an escape wire for the electrical current.

INSTALLATION INSTRUCTIONS

WARNING- Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the appliance is properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your
refrigerator to extension cords or together with any
other appliance in the same wall outlet.
The refrigerating system in this refrigerator is a
"Frost Free" system. This type of system requires no
user intervention (i.e. defrosting) other than selecting
required cooling temperatures and the usual care and
maintenance.
To avoid vibration, the cabinet must be set level. This
is accomplished by adjusting the (2) front leveling
legs, located under the refrigerator cabinet. To start
the refrigerator, turn the temperature control (1-max)
to the position corresponding to your desired cooling
temperature.
The refrigerator temperature will vary depending on
the quantity of food stored and the frequency with
which the door is opened.
1

Publicidad

Tabla de contenido
loading

Tabla de contenido