Danby Sunbeam DFF258BLSSB Guía A Utilizar Y A Cuidar Del Proprietario página 4

CAUTION
To avoid personal injury to yourself and/or property, we
recommend someone assists you during the door reversal
process.
1) To access the lower hinge assembly, tilt back the refrigerator
cabinet or lay the refrigerator on its back (Fig. A).
2) Remove both leveling legs located at the front of the cabinet.
3) Remove the screws holding the lower hinge assembly to the
cabinet (Fig. A).
4) Remove the main door assembly from the refrigerator cabinet
(open door and pull down).
5) Remove the screws from the middle hinge assembly. Then
remove the hinge and freezer door (Fig. B).
6) Remove (unscrew) the top hinge pin (Fig. C).
7) Re-install the main door top hinge pin on the opposite side of
the cabinet (Fig. C).
8) Remove the door plug and door bushing located on the top
and bottom of each door assembly(Fig. B)
9) Interchange positiones (ie. door plug right side, door bushing
left side).
10) Re-install freezer door assembly on cabinet.
11) Re-install the middle hinge assembly on the opposite side.
12) Make sure the door assembly is properly aligned on the
cabinet before tightening the hinge screws.
13) Re-install the main door assembly on the cabinet.
14) Re-install the lower hinge assembly on the opposite side,
making sure to change the bushing and screw on the opposite
sides on the bottom of unit.
15) Make sure the door assembly is properly aligned on the
cabinet before tightening lower hinge screws.
16) Re-install both leveling legs.
THE PROCESS IS NOW COMPLETE.
DOOR REVERSAL INSTRUCTIONS
Fig. A
Fig. B
3
Fig. C