Publicidad
Idiomas disponibles
Idiomas disponibles
Integrated AGC (Automatic Gain
Control) ensures a constant output
level in the Sat-IF range
EXE 2512 single-cable multi-switches
and additional loop-through multi-
switches such as EXE 259, EXR 2554,
EXR 2558 and EXR 2542 can be
combined as desired.
Up to eight multi-switches can be
cascaded
For indoor installation
EXE 1512
Single-cable multi-switch for up to 12
receivers, with an integrated power
supply unit for LNB supply
Low power consumption due to highly
efficient, short-circuit proof switched-
mode power supply unit in compliance
with ERP guideline and energy-saving
concept (the single-cable multi-
switch is switched off whenever the
connected receiver is switched off)
Kathrein Power Saving:
LNB supply is switched off as soon as
all receivers connected to the
EXE 1512 or in the cascade are inac-
tive. This function can be deactivated;
e.g. if loop-through multi-switches
without Kathrein Power Saving are
used in the cascade
LNB remote feeding via the horizontal
low input. Kathrein Power Saving
signalling over the vertical low trunk.
All other inputs are voltage-free
EXE 2512
Loop-through multi-switch to extend a
single-cable system for an additional
12 receivers
Kathrein Power Saving: As soon as all
receivers are inactive, a signal is sent
to the end multi-switch via the vertical
low trunk which then cuts off the LNB
voltage supply.
Optional powering using the NCF 18.
Due to the energy-saving concept, the
multi-switch consumes no energy from
the NCF 18 if no receivers are swit-
ched on.
2 / 8
Publicidad
