Replacing The Backing Pad - MIRKA DEOS 353 Instrucciones De Manejo

en
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!

Replacing the backing pad

The backing pad is fixed with 8 screws
A = 8 mm (only on 70 × 198 mm)
B = 16 mm
Remove
1 Turn the tool upside down
2 Remove the 4 screws (A)
3 Remove the 4 screws (B)
4 Remove the backing pad
Install
1 Fit the new pad
2 Fit the 4 screws (B)
3 Fit the 4 screws (A)
4 Finally tighten all 8 screws
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and
continuously with net products These cost-effective pad savers, placed between the backing pad and the sanding
strip, should be changed regularly The pad savers prolong the life of the backing pad
https://www mirka com/accessories/pad-savers//
Further service
Servicing must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service center To locate your local Mirka
authorized service center, contact Mirka Customer service or your Mirka dealer
50
Mirka® DEOS 353, 383 & Delta 663 • 230 V
A
B
A
B
B
A
B
A