Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Starting Engine
2_
3.
WARNING:
Be sure no one other than the operator
is standing near the lawn mower while starting
engine or operating mower. Never run engine
indoors or in enclosed, poorly ventilated areas.
Engine exhaust contains carbon monoxide, an
odorless and deadly gas. Keep hands, feet, hair and
loose clothing away from any moving parts on
engine and lawn mower.
When starting the engine for the first time, push primer (if
equipped) five times. For all future starts, push the primer
three times. Wait about two seconds between each push.
See Fig. 5-1. Do not prime to restart a warm engine.
Standing behind the mower, squeeze the blade control
against upper handle.
Holding these two handles together firmly, grasp recoil
starter handle and pull rope out with a rapid, continuous,
full arm stroke. See Figure 5-1. Keeping a firm grip on the
starter handle, let the rope rewind slowly. Repeat until
engine cranks. Let the rope rewind each time slowly.
Stopping Engine
1.
Release blade control to stop the engine and blade.
i_
WARNING:
Wait for the blade to stop completely
before performing any work on the mower or to
remove the grass catcher.
UsingYour lawn Mower
Be sure lawn is clear of stones, sticks, wire, or other objects
which could damage
lawn mower or engine. Such objects could
be accidently
thrown
by the mower in any direction
and cause
serious personal
injury to the operator
and others.
_
WARNING:
The operation
of any lawn mower can
result in foreign
objects
being thrown
into the eyes,
which can damage your eyes severely. Always wear
safety glasses while operating
the mower, or while
performing
any adjustments
or repairs on it.
Usingas Mulcher
For mulching
grass, remove the grass catcher and allow the rear
discharge
door to close the rear opening
of mower. For effective
mulching,
do not cut wet grass. If the grass has been allowed
to
grow in excess of four inches, mulching
is not recommended.
Use
the grass catcher to bag clippings
instead.
f
Figure S-1
UsingGrass Catcher
You can use the grass catcher to collect clippings
while you are
operating
the mower.
1.
Attach grass catcher following
instructions
in the
"Assembly
& Set-Up" section. Grass clippings
will
automatically
collect in bag as you run mower. Operate
mower till grass bag is full.
2.
Stop engine
completely
by releasing
the blade control.
Make sure that the unit has come to a complete
stop.
3.
Lift discharge
door and pull grass bag up and away from
the mower to remove the bag. Dispose of the grass
clippings
and reinstall the bag when complete.
WARNING:
If you strike a foreign object, stop the
engine. Remove wire from the spark plug,
thoroughly inspect mower for any damage, and
repair damage before restarting and operating.
Extensive vibration of mower during operation is an
indication of damage. The unit should be promptly
inspected and repaired.
13
Publicidad
