sunjoe 24V-X2-OGV-CT Manual Del Operador página 10

m
WARNING!
The chargers do not automatically turn
off when the battery is fully charged. Please take care not
to leave the battery plugged into the charger. Switch off or
unplug the charger at the mains when charging is complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
TOOL ONLY
BATTERIES + CHARGER SOLD SEPARATELY
In order to operate this cordless vacuum + mulcher you will
need iON+ 24V System batteries and charger. See page 16
for battery and charger options and specifications, or for
more information visit sunjoe.com.
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Do not insert the batteries until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
m
WARNING!
Before performing any maintenance, make
sure the tool is off and batteries are removed. Failure to heed
this warning could result in serious personal injury.
m
WARNING!
To prevent serious personal injury, make
sure the switch is not squeezed, the batteries are removed and
the impeller has come to a complete stop before attaching or
removing the collection bag.
1. Assemble the front wheel with the wheel hub as shown
below. Insert the shaft of the wheel hub into one of the
holes located on the side of the vacuum chute, and
rotate the wheel hub clockwise until it cannot be rotated
anymore (Fig. 4).
NOTE: Adjust the vacuum to obtain the optimal air inlet
height by aligning the wheel shaft to the hole at the
corresponding height.
2. Repeat the above assembly step for the other wheel,
make sure both wheels are set to the same height.
2-Position Height Adjustment:
1) Low: 1.4 in. (3.6 cm)
2) High: 2.2 in. (5.6 cm)
NOTE: Choose the air inlet height according to the
terrain that the vacuum will be working on. To work on
flat surface, lower the air inlet height. To work on lawn or
uneven surface, increase the air inlet height.
3. Flip down the collection bag support located on the
bottom of the chute (Fig. 5).
Fig. 5
4. To attach the collection bag, first place the bottom of the
collection bag on the collection bag support and insert
the tab on the chute into the hole on the bottom of the
collection bag, then align and insert the air outlet into the
hole on the top of the bag. Press firmly until it clicks and
locks securely into place (Fig. 6).
10
Wheel shaft
Front wheel
Wheel hub
Fig. 4
Collection bag
support