sunjoe 24V-X2-OGV-CT Manual Del Operador página 13

Clearing The Blocked Inlet/Outlet
During the vacuuming process, certain objects such as cloth,
rope or large diameter sticks may obstruct and block the air
inlet/outlet. An overcurrent protection device, which is built
into the vacuum, will cut off the power to the motor to prevent
damage from overheating. When this happens, follow the
instructions below to clean the blocked air inlet/outlet.
m
WARNING!
To avoid serious personal injury, be sure the
unit is OFF and batteries are removed before clearing the air inlet.
m
WARNING!
To avoid serious personal injury, always
wear gloves to protect yourself from any sharp objects.
1. Release the On/Off switch and wait until the unit comes to
a complete stop.
2. Remove the batteries
3. Remove the collection bag.
4. Turn the machine sideways to expose the air inlet. Wearing
protective gloves, carefully reach and remove the material
blocking the chute from the air inlet. Inspect to ensure no
damage has occurred.
5. Reinstall the collection bag. Wait 3 minutes for the motor
to cool.
6. Re-insert the batteries and start the unit. The vacuum will
resume normal function.
Cleaning the Unit
m
WARNING!
To avoid serious personal injury, always
turn the unit off and remove the batteries before cleaning or
servicing.
Use a small brush to clean the outside of the unit. Do not use
strong detergents, household cleaners that contain aromatic
oils (e.g. pine and lemon) or harsh solvents such as kerosene
as these substances can damage the plastic housing or the
handle. Wipe off any moisture with a soft, dry cloth.
1. Empty the bag after each use to avoid deterioration and
obstructing air flow, which will reduce the performance of the
vacuum + mulcher.
2. Wear eye protection and a dust mask. Clean the bag as
needed. Turn the bag inside out after initial emptying and
vigorously shake out dust and debris.
3. Wash the bag once a year, or more often if needed.
Follow the steps below:
i.
Remove the bag.
ii. Unclip the 2 Velcro bands used to secure the bag on
the supporting frame, and release the string that is
used to fix the bag on the upper slot of the frame.
Remove the collection bag from the frame (Fig. 13).
Fig. 13
Collection
bag
iii. Turn the bag inside out.
iv. Hang it up.
v. Hose it down thoroughly.
vi. Leave it hanging to dry.
vii. Turn the bag right-side out and reinstall.
Storage
1. Examine the cordless vacuum + mulcher thoroughly for
worn, loose, or damaged parts. Should you need to repair
or replace a part, contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
2. Remove the batteries from the cordless vacuum + mulcher
before storing.
3. Store the vacuum + mulcher in a dry, well-ventilated place
that is inaccessible to children. Keep away from corrosive
agents.
Disposal
Recycling + Disposal
The product comes in a package that protects it against
damage during shipping. Keep the package until you are
sure that all parts have been delivered and the product is
functioning properly. Recycle the package afterwards or keep it
for long-term storage.
WEEE symbol. Waste electrical products should not
be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority
or local store for recycling regulations.
Battery Caution + Disposal
Always dispose of your battery packs according to federal,
state, and local regulations. Contact a recycling agency in your
area for recycling locations.
13
Plastic frame
Velcro bands
+
®
+ Sun Joe
® ®