Starting + Stopping - sunjoe 24V-X2-OGV-CT Manual Del Operador

Fig. 6
NOTE: The collection bag must be attached any time
the unit is being operated. The unit cannot start if the
collection bag is not attached properly.
5. Press on the handle pivoting button and rotate the handle
at the same time, until the handle is fully extended and
clicks into the working position (Fig. 7).
Fig. 7
Handle pivoting
button
m
DANGER!
To avoid personal injury, the handle must be
fully extended in working position during operation.
Operation

Starting + Stopping

Do not switch on the vacuum until it has been completely
assembled.
m
WARNING!
Before switching on the vacuum, make sure
that it is not in contact with any foreign objects. Keep your
hands and feet a safe distance away from the bottom opening.
Failure to comply with these warnings can result in severe
personal injury.
1. Insert the batteries until you hear them click into place, then
close the compartment cover (Fig. 8).
Air outlet
Collection bag
Tab
Working
position
Storage position
Fig. 8
2. To start the unit, press the safety lock button, and squeeze the
On/Off switch. Once the machine powers on, release the safety
lock button and proceed with operation (Fig. 9).
Fig. 9
Safety lock
button
On/Off switch
3. This unit is equipped with a Turbo button that will allow
the vacuum to reach 850 CFM. Press and hold the Turbo
button to activate. Release the Turbo button to turn Turbo
mode off (Fig. 10).
Fig. 10
m
WARNING!
The Turbo button is for short term use only.
Do not use the Turbo function for extended periods of time.
Using this function for an extended time can cause damage.
4. To stop the unit, release the On/Off switch (Fig. 9).
11
Battery
compartment
cover
Battery
Battery
compartment
Turbo button