Dremel 7000 Instrucciones De Funcionamiento Y Seguridad página 26

1600A012FR_7000 2/1/17 10:11 AM Page 26
EZ Drum™ Mandrel No. EZ407SA has a spring loaded
sleeve and is used with sanding bands.
the plug from the power source or the battery pack
from the tool before changing accessories. Such
preventative safety measures reduce the risk of start-
ing the power tool accidentally.
Always make sure accessory is properly seated on
mandrel before use. Incorrect seating of accessory on
mandrel may lead to personal injury or property damage.
To load accessory:
1. As indicated, place two fingers underneath the man-
drel and pull firmly up. This will place the EZ Drum™
in the "unlocked" position (Fig. 1).
2. Keeping two fingers beneath the mandrel, slide the
sanding band down until the entire blue mandrel is
covered (Fig. 2).
3. To return to "locked" position, press firmly down on
the top of the mandrel (Fig. 3).
Removing the sanding band on
the mandrel:
1. Place two fingers underneath the mandrel and pull
firmly up. This will place the EZ Drum™ in the
"unlocked" position (Fig. 1).
2. Sanding band will now easily slide off mandrel (Fig.
2). Do not squeeze sanding band when removing
from EZ Drum™ mandrel. This can lead to rubber
band pulling off mandrel and becoming inoperable.
EZ Drum™ Operating Instructions
Always make sure the rotary
tool is "OFF" and disconnect
FIG. 1
FIG. 2
FIG. 3
26