Fuse Replacement; Cleaning - Kodak Ektalite E10 Instrucciones De Operación

Fuse Replacement

1. Move the POWER SWITCH to the "OFF" position.
2. Disconnect the power cord and wait until the unit is completely cool.
3. Locate the fuse (see diagram). Use a screwdriver to remove the fuse
cover, then remove the used fuse.
4. Install a new fuse with the correct rating. Replace the fuse cover.
Lamps
EYB, EHJ, EVD 250Volt
For 36V400w
For 24V250w
For 82V360w
Lens and Glass Cleaning and
Maintenance
Lens and Glass Cleaning and Maintenance
1. Clean the PROJECTION MIRROR, PROJECTION LENS, Fresnel lens
(inside), and STAGE GLASS with a clean, lint-free cloth.
Note:
Fresnel lens is on inside of TOP COVER. Turn clips to remove. When replac-
ing, make sure the "UP" label faces the STAGE GLASS side.
Fuse Rating
125Volt
T3.15A T10A
T3.15A T6.3A
T6.3A
22
KODAK EKTALITE E10/E11/E12 OVERHEAD PRO-