Flex FX1171T Manual Del Operador página 17

WARNING
product damage due to a short circuit, never
immerse your tool, battery pack or charger
in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
VARIABLE-SPEED TRIGGER SWITCH
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned ON or
OFF by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This Drill Driver/ Hammer Drill must be used only with the battery packs and chargers listed
below:
2.5Ah 5Ah
FLEX FX0111 FLEX FX0121
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
DRILLING (FIG. 17)
WARNING
with side shields during power tool
operation or when blowing dust. If operation
is dusty, also wear a dust mask.
a. Check that the direction-of-rotation selector is
at the correct setting (forward or reverse).
b. Secure the material to be drilled in a vise or
with clamps to keep it from turning as the drill
bit rotates.
c. Hold the drill firmly and place the bit at the
point to be drilled.
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
(FIG. 16)
If any parts are damaged
or missing, do not operate
Battery Pack
8Ah
FLEX FX0221
Always wear safety
goggles or safety glasses
Fig. 16
Variable-Speed
Trigger Switch
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
12Ah
FLEX FX0231
Fig. 17
-17-
To prevent accidental
starting that could cause
Charger
FLEX FX0411 FLEX FX0421