How To Use - Vornado TAVH10 Guia Del Propietario

HOW TO USE

Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Use integrated handle on back of heater
for lifting and carrying.
2. Position heater so airflow is
not obstructed.
3. Unwrap power cord from bottom of
heater. Plug power cord into standard
grounded wall outlet.
Wrap excess cord inside Cord Storage.
Use notches inside the Cord Storage,
to secure power cord in place or adjust
length during use.
COOL DOWN
When you power off your heater, it automatically enters a
cool down routine in which the heating element turns off
and the fan exhausts remaining heat. During Cool Down, the
display counts down from eight, then powers off completely.
4. Touch the power button
Mode . Next, set thermostat to desired
temperature using -/+. After selecting set
temperature the display will dim. You may
also select Fan Only by touching
settings upon first use will be High Heat and set
temperature of 75 degrees.
Set timer to automatically power unit off by
touching . 0 will flash on the display. Touch
or -/+ to select amount of time in one-
hour intervals, up to 12 hours. To cancel timer
operation, select 0 hours. Timer will set after
five seconds of making selection.
After timer is in operation, remaining amount of
time before heater powers off counts down on
display. If you touch during operation, time
remaining flashes, and if
time, timer cancels.
and select
. Default
is touched a second
English
9