DeWalt DWE46202 Manual De Instrucciones página 10

English
5. Place the wheel onto the work surface and move the
grinder from right to left to cut around the inside corner
for best dust collection.
6. Remove the tool from work surface before turning tool
off. Allow the tool to stop rotating before laying it down.
7. Close the corner door and lock in place using the
cornering door locking lever
Fig. E
Dust Extraction (Fig. F)

WARNING: Use only power tools and dust
extractors recommended by D
tuckpointing shroud.
For more information about D
compatible with this tuckpointing shroud, please contact
your local dealer, call 1–800–4-D
or visit our website www.D WALT.com.
e

WARNING: The tuckpointing shroud must be used
with a dust extractor system. ALWAYS wear certified
safety face and appropriate dust mask.
nOTE: Ensure hose connection is secure.
nOTE: The amount of dust retained by the dust extractor
vacuum is dependent on its filter system. Refer to the dust
extractor vacuum instruction manual for more information.
All D WALT dust collection shrouds are designed to work
e
with the D WALT Air lock™ universal DWV9000 connector.
e
1. Attach the DWV9000 connector
collector hose 19 .
2. Unlock the DWV9000 connector
port .
10
3. Lock the DWV9000 connector
Fig. F
19
15
10
8
14 .
9
14
WALT with the
e
WALT power tools
e
WALT (1–800–433–9258)
e
15 to your dust
15 and slide onto dust
to secure.
15
Traditional dust extractor vacuum
hoses
Attach recommended dust extractor vacuum hose to dust
port 10 .
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
1. Ensure all assembly and adjustment instructions have
been completed.
2. Turn the dust extractor vacuum on as instructed in the
dust extractor vacuum instruction manual.
3. Start grinder as instructed. Refer to Slider Switch.
nOTE: Allow the tool to reach full speed before
applying to the work surface.
Proper Hand Position (Fig. G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the side handle,
with the other hand on the body of the tool, as shown in
Figure G.
Fig. G
Slider Switch (Fig. A)

CAUTION: Hold the side handle and body of the tool
firmly to maintain control of the tool at start up and
during use and until the wheel or accessory stops
rotating. Make sure the wheel has come to a complete
stop be fore laying the tool down.
nOTE: To reduce unexpected tool movement, do not
switch the tool on or off while under load conditions. Allow
the grinder to run up to full speed before touching the work
surface. Lift the tool from the surface before turning the tool
off. Allow the tool to stop rotating before putting it down.

WARNING: Before connecting the tool to a power
supply, be sure the slider switch is in the off position
by pressing the rear part of the switch and releasing.
Ensure the slider switch is in the off position as
described above after any interruption in power
supply to the tool, such as the activation of a ground
fault interrupter, throwing of a circuit breaker,
20