Installation - Hotsy HHD 5/30 G Manual Del Operador

Safety
Latch
WARNING! Never replace
nozzles without engaging the
safety latch on the spray gun
trigger.
The four color-coded quick connect nozzles provide a wide array of spray
widths from 15° to 40° and are easily accessible when placed in the con-
venient rubber nozzle holder, which is provided on the front of the machine.
NOTE: For a more gentle rinse, select the white 40° or green 25° nozzle.
To scour the surface, select the yellow 15° nozzle. To apply detergent,
select the black nozzle.
GETTING STARTED
IMPORTANT: Proper initial installation of equipment
will assure more satisfactory performance, longer
service life, and lower maintenance cost.
IMPORTANT: The use of backflow preventer on the
water supply hose is recommended and may be
required by local code.
10
OPERATING INSTRUCTIONS
WARNING! Starter cord kickback (rapid retraction) can result in
bodily injury. Kickback will pull hand and arm toward engine faster
than you can let go. ALWAYS relieve spray gun pressure before
pulling starter cord. Pull starter cord slowly until resistance is felt,
then pull rapidly.
NOZZLES

INSTALLATION

Manual Operator High Flow Hotsy
IMPORTANT: DO NOT run machine indoors or in an
enclosed area where high ambient temperatures
exist. High ambient temperatures (above 100° F)
can cause engine oil failure and will greatly reduce
the engine's performance.
VENTING
CAUTION: All venting must be in accordance with
applicable federal and state laws, and local ordi-
nances. Consult local heating contractors.
9.808-131.0