Char-Broil Patio Bistro 360 15601832 Guía Del Producto página 9

CAUTION
SPIDER ALERT!
SPIDER AND WEBS
INSIDE BURNER
Your burner might be different
If your grill is getting hard to light or the flame is weak,
check and clean the venturis and burners.
Spiders or small insects are known to create "flashback"
problems by building nests and laying eggs in the grill's
venturi or burner, obstructing the flow of gas. The back-
up gas can ignite behind the control panel. This
flashback can damage your grill and cause injury. To
prevent flashbacks and ensure good performance the
burner and venturi tube assembly should be removed
and cleaned when ever the grill has been idle for an
extended period of time.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting appliance.
1. Turn gas OFF at control knob and LP cylinder and
disengage regulator from cylinder.
2. Open top cover, remove cooking grate, heat tent and
warming rack, shown A. This will expose the burner from
inside, shown B.
3. Remove 2 screws securing burner, shown C
4. From the top of the grill, carefully lift burner out, shown D.
5. Clean any blocked ports with a stiff wire such as an open
paper clip.
6. Clean burner as recommended below, shown E.
We suggest three ways to clean the burner tube. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run hook through burner tube several
times.
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through burner
tube several times.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
7. Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or
holes are found replace burner.
8. Insert burner into firebox .
VERY IMPORTANT: Burner tube must re-engage over valve
opening. See illustration, shown F.
9. Reattach burner using screws removed in step 3.
10. Reinstall heat tent, cooking grates and warming rack.
Warming
Cooking
Rack
Grate
Heat Tents
Screws
Tube cleaner
(see above
recommendations)
Burner
(removed)
9
A
Burners
(exposed)
C
Remove
Burner
E
Burner
Burner
Tube
Tube
Valve
Valve engaged inside burner
tube end correctly
B
D
F