Porter Cable PCE810 Manual De Instrucciones página 10

NOTE:
Do not engage the spindle lock
while the tool is operating. Damage to the
tool will result and attached accessory
may spin off possibly resulting in injury.
To engage the spindle lock, depress the
spindle lock button shown in figure E and
rotate the spindle until you are unable to
rotate the spindle further.
E
MOUNTING AND USING
DEPRESSED GRINDING WHEELS
AND SANDING FLAP DISCS
MOUNTING AND REMOVING
HUBBED WHEELS
WARNING:
operation, turn off and unplug tool
before performing the following
operations. Failure to do this could result
in serious personal injury.
Hubbed wheels install directly on the 5/8
in.-11 threaded spindle.
1. Thread the wheel on the spindle by hand.
2. Depress the spindle lock button and use a
wrench to tighten the hub of the wheel.
3. Reverse the above procedure to remove
the wheel.
Failure to properly seat the wheel before
turning the tool on may result in damage to
the tool or the wheel.
MOUNTING NON-HUBBED WHEELS
WARNING:
operation, turn off and unplug tool
before performing the following
operations. Failure to do this could result
in serious personal injury.
Depressed center Type 27 grinding wheels
must be used with included flanges.
1. Figure F - Install the unthreaded backing
flange (11) on spindle (12) with the
raised section (pilot) against the wheel.
2. Place wheel against the backing
flange, centering the wheel on the
raised section (pilot) of the backing
flange.
6
To prevent accidental
To prevent accidental
3. Figure G - While depressing the
spindle lock button, thread the
threaded clamp nut (13) on spindle.
Figure H - If the wheel you are installing
is more than 1/8 inch (3mm) thick,
place the threaded clamp nut on the
spindle so that the raised section (pilot)
fits into the center of the wheel.
Figure I - If the wheel you are installing
is 1/8 inch (3mm) thick or less, place
the threaded clamp nut on the spindle
so that the raised section (pilot) is not
against the wheel.
4. While depressing the spindle lock
button (6), tighten the threaded clamp
nut with included wrench.
5. To remove the wheel, depress the spindle
lock button and loosen the threaded
clamp nut with included wrench.
NOTE
:
If the wheel spins after the
threaded clamp nut is tightened, check
the orientation of the threaded clamp nut.
If a thin wheel is installed with the pilot on
the clamp nut against the wheel, it will spin
because the height of the pilot prevents the
clamp nut from holding the wheel.
F
11
G
13
H
1/4 inch wheels
10
12
Threaded clamp nut
Backing flange