Manual Operation (Cool, Dry, Heat) - Mitsubishi Electric Mr.SLIM MSH24W Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MANUAL OPERATION (COOL, DRY, HEAT)

To select the COOL, DRY or HEAT mode
1
2
To stop operation:
˚F
I
CLOCK
AMPM
AMPM
TOO
TOO
ON/OFF
WARM
COOL
I
FAN
STOP
I FEEL COOL
VANE
START
HEAT
DRY
MODE
WIDE VANE
HR.
LONG
MIN.
RESET CLOCK
I
NOTE
When the ambient temperature is too high, the room tem-
perature may not reach the set temperature since the unit
operates to cool the room under a high load.
8
ON/OFF
Press the
button.
Select the operation mode by pressing the
MODE
button.
Each time this button is pressed, the operation mode
(I FEEL...) → → → → →
is changed in sequence:
(COOL)
→ → → → →
(DRY) → → → → →
(HEAT)
ON/OFF
Press the
button.
After the operation mode is set once, the operation
starts in the same mode as the one set previously
from the next time by simply pressing the
ON/OFF
button.
When the set temperature is to be changed:
TOO
WARM
I Press the
button to lower the temperature. One
°
press lowers the temperature by about 2
F.
TOO
COOL
I Press the
button to raise the temperature. One
°
press raises the temperature by about 2
F.
In HEAT operation
I If the air conditioner absorbs too much heat from
the air, it may be overloaded. Following a judgement
made by the microprocessor, the fan in the outdoor
unit is automatically stopped to protect the air con-
ditioner.
When the outdoor unit's fan is stopped, frost may
form on the outdoor unit, but this is not a problem.
In DRY operation
I The temperature control (temperature setting) can-
not be done.
I The room temperature is slightly lowered in this
operation mode.
The details of the display on the indoor unit
are explained on page 7.
CONVENIENT INFORMATION
COOL
For effective cooling
1 Close the windows and pull
2 Paste a heat shield film (gen-
down blinds. Sunshine is re-
erally available) on the window.
duced and cooling efficiency
Heat entering the room is re-
increases.
duced.
HEAT
Comfortable warmth depends on the temperature difference between the indoor and
the outdoor.
It is recommended that the set temperature in the heating operation does not differ from the external tem-
perature too much. Though there is a regional difference, as a reference, a set temperature between about
71 °F and 75 °F would be suitable.
DRY
The humidity at which people feel comfortable
When air contains too much moisture, people feel uncomfortable. Humidity is related to temperature and
wind. The humidity at which people feel comfortable is 60 % - 75 % RH in summer, 55 % - 70 % RH in
winter.
Description of "AUTO RESTART FUNCTION"
Refer to page 7.
3 Block the outdoor unit from di-
rect sunlight. This saves en-
ergy.

Publicidad

Tabla de contenido
loading

Tabla de contenido