Andis AGC2 Manual Del Usuario página 3

8. Do not use this appliance with a damaged or broken blade or
comb, as injury to the skin may occur.
9. To disconnect turn control to "off" then remove plug from outlet.
10. wArNING: During use, do not place or leave appliance where it
may be (1) damaged by an animal or (2) exposed to the weather.
SAvE tHESE INStruCtIoNS
tHIS produCt INtENdEd for profESSIoNAL uSE
To reduce the risk of electric shock, this appliance has a polarized plug (one
blade is wider than the other). This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper outlet. Do not change
the plug in any way.
opErAtING INStruCtIoNS
Please read the following instructions before using your new Andis clipper. Give
it the care that a fine precision built instrument deserves and it will give you
years of service. Plug cord into electrical outlet, operate 120 volt, 60 cycle AC
electrical current or as noted on unit.
2-SpEEd opErAtIoN
Your Andis clipper comes with normal and high speed operation (Diagram A).
Use the normal setting (setting #1) for most cutting needs. Use the high speed
setting (setting #2) for cutting through heavy hair. To start clipper move switch
button by pressing down on the lock mechanism and moving to the #1 or #2
position. To stop, press down on the lock mechanism and move switch button
back to original position. After using your Andis clipper, rewrap cord, and store
in a safe place.
rEmovING bLAdE SEt
To remove blade set, first make sure your clipper motor is switched "OFF". Push
blade release mechanism under blade hinge (Diagram B). While holding down
the blade release mechanism, push down on blade, then gently pull the blade
forward (Diagram C), and slide it off the blade hinge. If your blade hinge should
snap closed and is flush with the clipper, use a small standard screwdriver to
pry the tongue of the hinge out (Diagram D). NotE: Hair may accumulate in the
front cavity of the housing under the blade. If this happens, you can clean out
the hair by brushing out the cavity with a small brush or an old toothbrush while
the blade is off the clipper (See Diagram E for location of cavity being referenced).
3