Relnstaillng
the Refrigerator
Door
Left Door
1. Lower the door onto middle
hinge pin (10).
2. Fit top hinge (7) over hinge lever latch (8) and into
place. Rotate lever (6) clockwise
to secure hinge.
3. Install the grounding
screw (5) and connect the two
wire harnesses (4).
4. Push the water tube (3) located
at the top of the left
door into the hole beside the left hinge on the top of
the cabinet until it exits through the back.
5. Insert the water supply tube (3) into the connector
until
you see only one scale mark. Fully insert the tube over
5/8 in. (15 mm).
6. Hook tabs on left side of hinge cover (1) under the
edge of the top hinge (7) and position the cover in
place. Insert and tighten the cover screw (1).
(2)
(3)_
(6) -f
(7)/
(8)
/
/
Right Door
1. Lower the door onto middle
hinge pin (9).
2. Fit top hinge (4) over hinge lever latch (5) and into
place. Rotate lever (3) counterclockwise
to secure
hinge.
3. Hook the tabs on right side of hinge cover (2) under
the edge of the top hinge (4) and position the cover in
place. Insert and tighten the cover screw (1).
(1)
<
_(4)
/(2)
(lO)
J I
CAUTION
Cotlet
Tube
Scale Mark
Ctip --
After inserting, pull the tube to
make sure that it is secure and
reinsert the clip.
14