Sears Kenmore 795.7032 Serie Manual De Uso Y Cuidado página 40

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

iCE & WATER
Icemaker is not
Refrigerator
was recently
installed or
It may take up to 24 hours for each compartment
to
making ice.
icemaker
recently
connected,
reach the desired temperature
and for the icemaker
to
begin making ice.
Icemaker
not turned on.
Locate the icemaker
ON/OFF
switch and confirm
that
it is in the ON (I) position.
The ice detecting
sensor is obstructed.
Foreign substances or frost on the ice-detecting
sensor
can interrupt
ice production.
Make sure that the sensor
area is clean at all times for proper operation.
The refrigerator
is not connected
to
Connect
refrigerator
to the water supply and turn the
a water supply or the supply shutoff
water shutoff valve fully open.
valve is not turned on.
Not dispensing water.
Icemaker shutoff (arm or sensor)
obstructed.
Reverse osmosis water filtration
system is connected
to your cold
water supply.
New installation
or water line recently
connected.
If your icemaker
is equipped
with an ice shutoff arm,
make sure that the arm moves freely. If your icemaker
is equipped
with the electronic
ice shutoff: sensor,
make sure that there is a clear path between the two
sensors.
Reverse osmosis filtration
systems can reduce the
water pressure below the minimum amount and result
in icemaker
issues. (Refer to the Water
Pressure
section.)
Dispense 2.5 gallons of water (flush for approximately
5 minutes) to remove trapped
air and contaminates
from the system. Do not dispense the entire 2.5
gallon amount continuously.
Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
The dispenser panel is locked.
Press and hold the Lock button for three seconds to
unlock the control panel and dispenser.
The dispenser is not set for water
The dispenser can be set for ice or water. Make
dispensing,
certain that the control panel is set for the proper
operation.
Press the Ice/Water
Select button on the
control panel.
Refrigerator
or freezer doors are not
Water
will not dispense if any of the refrigerator
closed properly,
doors are left open.
Water filter has been recently
removed or replaced.
Tubing connecting refrigerator
to
house supply valve is kinked.
The house water
supply
is not
connected,
the valve
is not turned
on
fully,
or the valve
is clogged.
After the water filter is replaced,
dispense 2.5 gallons
of water (flush for approximately
5 minutes) to remove
trapped
air and contaminates
from the system. Do not
dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
The tubing can kink when the refrigerator
is moved
during installation
or cleaning
resulting in reduced
water flow. Straighten
or repair the water supply line
and arrange
it to prevent future kinks.
Connect
refrigerator
to the water supply and turn the
water shutoff valve fully open.
If the problem
persists, it may be necessary to contact
a plumber.
4O

Publicidad

Tabla de contenido
loading

Tabla de contenido