Canopy Assembly; Blade Assembly - Craftmade Jamison JAM52 Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the
open end of the hanging bracket. Partially
loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of
slotted hole in canopy over loosened
screw in hanging bracket and push up.
Twist canopy to lock. Re-insert screw that
was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy
cover with screwheads in bottom of
canopy. Turn canopy cover to the right
(clockwise) until it stops.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools
to assemble the blades. If overtightened,
blades may crack and break.
Time Saver: Washers for blade screws
can be set on each blade screw prior to
installing blades.
Locate 15 blade attachment screws and
washers in hardware packs. Hold blade
arm up to blade and align holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for the
remaining blades.
Remove blade arm screws/lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade
arm screws/lock washers to secure blade
arms). Align blade arm holes with motor
screw holes and attach blade arm with
blade arm screws/lock washers. Before
securing screws permanently, repeat this
procedure with remaining blade arms.
Securely tighten all screws.
NOTE: Tighten blade arm screws twice a
year.
canopy cover
plastic
motor
lock
page 7
hanging bracket
canopy
screw
motor
housing
blade attachment
screws/lock washers
blade
blade arm
blade arm screws/
lock washers