Step 2: Connecting The Ac Adaptor; Step 3: Preparing The Headset - Sony DR-GA500 Manual De Instrucciones

Step 2: Connecting the AC Adaptor

Connect the supplied AC adaptor to the processor, and then connect the AC adaptor to the AC
outlet.
Rear panel of processor

Step 3: Preparing the Headset

1
Connect the  (microphone) plug of the headset to the HEADSET (MIC IN) jack of
the processor, and connect the  (headphone) plug to the HEADSET (PHONES)
jack.
Rear panel of processor
2
Adjust the band of the headset, and wear the earpad marked  on your right ear,
and the one marked  on your left ear.
Note
If the position of the microphone is not correct, the sensitivity of the microphone will decrease, and sound
from the headphone may enter the microphone.
1
GB
Connection
To DC IN 5.V jack
AC adaptor (supplied)
Headset
Black
Red
There is a tactile dot on the
hanger marked  to
distinguish the left side.
Adjust the position of the
microphone for effective pickup of
your voice.
Return the position of the
microphone to rest near the earpad
when not in use.
To AC outlet