72 OZ. PITCHER
(Max Liquid Capacity: 64 oz)
A
CAUTION: THE BLADE ASSEMBLY
IS NOT LOCKED IN PLACE. IF USING
THE POUR SPOUT, ENSURE THE
LID IS FULLY LOCKED ONTO THE
BLENDER PITCHER.
ASSEMBLY
ASSEMBLY:
OF THE 72 OZ.
WARNING: NEVER LEAVE THE APPLIANCE
UNATTENDED WHILE IN USE.
PITCHER
CAUTION: USE CAUTION WHEN HANDLING
(Max Liquid Capacity: 64 oz)
THE BLADE ASSEMBLY AS IT IS VERY SHARP.
NOTE: Ninja
®
Auto-iQ
™
IMPORTANT: MAKE SURE THE MOTOR BASE IS
Technology can sense
PLUGGED IN FOR USE.
which container is on
1
Holding the Blade Assembly by the top of the shaft,
the motor base. The
place it onto the drive gear (A) inside the pitcher.
function lights will
Ensure that the attachment is seated properly and is
illuminate depending
standing upright.
on which container is
NOTE: THE BLADE ASSEMBLY WILL FIT
placed on the motor
LOOSELY ON THE DRIVE GEAR.
base.
1 0
B
C
CAUTION: THE BLADE
ASSEMBLY IS NOT LOCKED IN
PLACE. IF POURING WITH THE
LID REMOVED, ALWAYS REMOVE
THE BLADE ASSEMBLY FIRST.
®
D
E
ASSEMBLY
ASSEMBLAGE
ARMADO
2
Place the motor base on a clean, dry, level surface
such as a counter or tabletop. Press down on the
motor base to make sure the suction cups adhere to
the counter or tabletop.
3
Align and lower the pitcher (B) onto the motor
base. Handle should be aligned slightly to the right of
the LOCK symbol on the motor base.
4
Rotate the pitcher clockwise (C) until it locks in place
(you will hear a click when the lock is engaged).
5
The pitcher can be placed on the motor base two
ways; the handle can align with the front right corner
(D) or the front left corner (E).
6
Add the ingredients to the pitcher, making sure they
do not exceed the highest measured marking line on
the side of the pitcher.
w w w . n i n j a k i t c h e n . c o m
F
IMPORTANT: DO NOT OVERFILL. TO AVOID
SPILLING, DO NOT ADD INGREDIENTS PAST
THE "MAX LIQUID" LINE.
NOTE: When blending any kind of liquids, such as
mixtures of any drinks or smoothies, do not exceed
the MAX LIQUID mark (64 ounces) on the pitcher.
NOTE: If you need to add additional ingredients
once the appliance is processing, turn the unit OFF,
open the pour spout cap, and pour the ingredients in
through the opening.
7
Holding the lid by the handle in the upright position
(F), place it on top of the pitcher aligning the triangle
( ) located on the lid with the triangle ( ) located
on the pitcher handle. Press the handle down until
you hear a click.
8
The triangles on the lid and the pitcher handle (G)
MUST be aligned for the blender to turn on.
9
Plug the power cord into the electrical outlet. The
function lights will illuminate.
G