6. Packaging
6. Packaging
Has everything been supplied?
Check the scope of supply:
Completely assembled transducer
■
Inspect the transducer for possible damage during transportation. Should there be any obvious damage,
■
inform the transport company and WIKA without delay.
The transducer is purified, evacuated and double-bagged for clean-room service and should remain
■
packaged until installation. A protective cap is used to protect the face sealing beads from nicks or
scratches. This plug should remain in place during storage and handling, in order to prevent damage to the
bead. Therefore remove the inner ESD (Electro-Static-Discharge) bag only at the place of installation.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing installation
■
location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be damaged.
■
Remove this protection cap only just before installing the pressure transmitter
■
Mount the protection cap when removing and transporting the instrument.
■
Unpack the transducer
1. Remove the transducer from the box.
2. Remove the outer protective bag and discard.
3. Carry the transducer (sealed in the inner bag), into the clean area.
6
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio WU-1X
GB