Important Details For Your Information - WIKA OBSOLETE WU-10 Manual De Instrucciones

1. Important details for your information

1. Important details for your information
Read these operating instructions before installing and starting the pressure transmitter. Keep the operating instructions in a
place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care but it is not feasible to take
all possible applications into consideration. These installation and operation instructions should meet the needs of most
pressure measurement applications.
If questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.wika.de/www.wika.com
■
The product data sheet is designated as PE 87.05
■
Contact WIKA for additional technical support (+49) 9372 / 132-8976
■
With special model number, e.g. WU-10000, WU-15000 or WU-16000, please note specifications in the delivery note.
If the serial number on the product label gets illegible (e.g. by mechanical damage or repainting), the retraceability of the
instrument is not possible any more.
WIKA transducers are carefully designed and manufactured using state-of-the-art technology. Every component under-
goes strict quality and environmental inspection before assembly and each instrument is fully tested prior to shipment. Our
environmental management system is certified to DIN EN ISO 14001. The finished instrument was tested, cleaned and
carefully packaged in a protective atmosphere prior to shipment.
Use of the product in accordance with the intended use WU-1X:
Use the transducer to transform the pressure into an electrical signal.
Knowledge required
Install and start the transducer only if you are familiar with the relevant regulations and directives of your country and if you
have the qualification required. You have to be acquainted with the rules and regulations on hazardous areas, measurement
and control technology and electric circuits, since this transducer is „electrical equipment" as defined by EN 50178. Depend-
ing on the operating conditions of your application you have to have the corresponding knowledge, e.g. of aggressive media.
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio WU-1X
GB
3