Problem
Does not drain and/
or spin.
The door does not
open.
Excessive suds.
Cannot add additional
detergent.
Untitled-17 53
• Make sure the drain hose is neither kinked nor obstructed all
the way to the drain system. If there is a drain restriction, call
for service.
• Make sure the debris filter is not clogged.
• Close the door and press or tap Start/Pause (Hold to Start).
For your safety, the washer will not tumble or spin unless the
door is closed.
• Make sure the drain hose is not frozen or clogged.
• Make sure the drain hose is connected to a drain system that
is not clogged.
• If the washer is not supplied with sufficient power, the
washer temporarily will not drain or spin. As soon as the
washer regains sufficient power, it will operate normally.
• Press or tap Start/Pause (Hold to Start) to stop the washer.
• It may take a few moments for the door lock mechanism to
disengage.
• Make sure all the water in the drum is drained.
• The door may not open if water remains in the drum. Drain
the drum and open the door manually.
• Make sure the door lock light is off. The door lock light turns
off after the washer has drained.
• If the washer is paused after the water is supplied, the door
cannot be opened until one minute has passed. If draining
occurs followed by the information code on the display,
the door will not open until 3 minutes after the washer has
stopped or the power is turned off.
• Make sure you use the recommended types and amounts of
detergent.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Reduce the detergent amount for soft water, small loads, or
lightly soiled loads.
• Don't use Non-HE detergent.
• Make sure the remaining amount of detergent and fabric
softener is not over the limit.
Action
English 53
2019-05-08 PM 4:17:53