Schumacher Electric INSTANT POWER IP-95L Manual Del Dueño página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Appliance Type
Estimated Wattage
Electrical Tools
Electrical Coolers
Car Vacuum,
Air Compressors
The DC socket has a 15 amp automatic overload protection circuit
breaker. Reset the breaker by pushing the breaker button located
on the back of IP-95L.
110 Volt ac power source chart
(Inverter {Not Included} Is Necessary)
Appliance Type
Estimated Wattage
Spot Lights, Sump Pumps
VCRs
Faxes, TVs
Small Power Tools
When the IP-95L is used with an inverter, it can operate appliances
normally powered by 110V AC. (Inverter not included; must be
purchased separately.)
*NOTE: Estimated time is conservatively reported. Actual time may
vary. Times are based on IP-95L having a full charge. Requires
the use of an inverter that is not included. Designed for up to a 125
watt inverter.
using the Built-in swiVel light
The built-in swivel light is located on the left side of the IP-95L.
With a fully charged internal battery, the built-in light should provide
18 to 26 hours of continuous useful light, depending on ambient
conditions.
Schumacher Electric Corporation warrants your unit to be free from defects in material and workmanship, excepting abuse or misuse, for a period of
one year from the date of sale to the original user or consumer purchaser. If your unit fails or malfunctions within the first 30 days of the warranty, we
will replace it with a new unit. If your unit malfunctions or fails within the 12 month warranty period because of a defect in material or workmanship, we
will repair without charge.
The internal battery, excluding units with swollen batteries or melted battery terminals, carries a 90-day warranty from the date of purchase. Proof of
purchase required. All battery replacements will be at the sole discretion of the manufacturer or his designated agents.
This warranty is in lieu of all other express warranties. The duration of any implied warranty, including but not limited to any implied warranty of merchantability
or fitness for a particular purpose, made in respect to your unit is limited to the period of the express warranty set forth above.
For warranty service, return your product, with proof of purchase, to the factory or a designated agent: Schumacher Electric Corporation Warranty Service
Department, 1025 E. Thompson Street, PO Box 280, Hoopeston, IL 60942. Phone 1-800-621-5485, Customer Service hours: 7 AM to 4:30 PM CST.
You will be responsible for all insurance and freight or other transportation charges to the factory or point of repair. We will return your unit freight
prepaid if repair is covered under warranty. Your unit should be properly packed to avoid damage in transit, since we will not be responsible for any such
damage.
In no event shall Schumacher Electric Corporation be liable for consequential or incidental damages. Some states do not allow limitations on the length
of the implied warranty or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
Call Customer Service if you have questions: 1-800-621-5485 (Hours: 7 a.m. – 4:30 p.m. CST)
Estimated Time*
24 Watts
4 Hours
48 Watts
1.5 Hours
80 Watts
45 Minutes
Estimated Time*
100 Watts
45 Minutes
100 Watts
45 Minutes
125 Watts
35 Minutes
125 Watts
35 Minutes
limited warranty
CONTAINS SEALED NON-SPILLABLE LEAD-ACID BATTERY. MUST
BE DISPOSED OF PROPERLY.
WARNING: Possible explosion hazard. Contact with battery acid may
cause severe burns and blindness. Keep out of reach of children.
801 Business Center Drive, Mount Prospect, IL 60056-2179
Send Warranty Product Repairs to: Schumacher Electric Corporation
1025 East Thompson, Hoopeston, IL 60942-0280
1.
Position the
IP-95L
on a flat, stable surface near the intended
work area.
2.
Pull tab up to remove light from storage. Turn light in direction
needed.
3.
To turn light ON, push black button above light.
4.
To turn light OFF, push the black button.
IMPORTANT: Turn OFF light before placing light in its storage
space otherwise battery drain occurs.
5.
Charge
IP-95L
as soon as possible after using built-in light.
replacing the Built-in swiVel light BulB
1.
Turn light OFF.
2.
Carefully unscrew the back plate of the lamp housing.
3.
Gently grasp the bulb and twist until notch in bulb lines up with
retaining tab.
4.
Insert a replacement bulb of same type and rating, and twist
clockwise one quarter-turn to screw in new bulb.
5.
Carefully screw on the back plate of the lamp housing.
6.
Test light by switching light ON and OFF.
7.
Replace lens cover if necessary.
storage
The IP-95L can be stored in any position. The clamps are live and
will produce arcing or sparking if they come in contact with each
other. To prevent accidental arcing, always keep the clamps on the
side ears when not using it to jump start a vehicle.
All batteries are affected by temperature. The ideal storage
temperature is at 70 degrees Fahrenheit. Performance varies based
on battery temperature conditions.

Publicidad

Tabla de contenido
loading

Tabla de contenido