Fracarro FRPRO 06 Instrucciones De Funcionamiento página 29

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FRACARRO
FRPRO10
Enter PIN
Enter code
Setting the input
parameters and cluster
Automatic settings of gain
self-aligment
Manual setting of gain
Power supply ON/OFF on
the UHF1-UHF2- inputs
From the initial menu, 5 sub-programming items are available:
CONTROL UNIT settings: the main functions of this menu are language selection, management of the ac-
cess PIN, loading/saving the file from the USB pen drive and resetting the unit to the factory settings.
INPUT settings: the main functions of this menu are the definition and programming of UHF clusters, setting
the B.III+DAB input gain, FM input gain, AUX auxiliary input gain.
SELF-ALIGNMENT settings: the function of this menu is to enable the self-alignment of the gains in order to
automatically equalize the clusters, guaranteeing the best noise figure and the maximum output level.
Setting the FINAL GAIN: the function of this menu is to program the final gain to increase/decrease the level
of all amplified signals after the self-alignment.
Setting the REMOTE POWER SUPPLY: the function of this menu is to remotely manage UHF power supply
(independently).
5.1 INITIAL MENU
Setting the headend
parameters
CONTROL
UNIT SETUP
INPUT
SETTINGS
SELF-ALIGNING
SETTINGS
FINAL GAIN
SETTINGS
POWER SUPPLY
SETTINGS
29
30
see page
32
see page
34
see page
36
see page
36
see page

Publicidad

Tabla de contenido
loading

Tabla de contenido