Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TEMPERATURE SELECTION GUIDE
1.
Check for textile care symbols.
2.
Iron fabrics needing low temperatures first, then those that need medium
temperatures , and finish with those needing high temperatures (or max).
3.
Turn the temperature control dial to the appropriate setting for your fabric.
If the instructions on the fabric label differ from this guide, follow the instructions
on the label.
L
abel marking
cool – nylon, acrylics, polyester
warm – wool, polyester mixtures
hot – cotton, linen
do not iron
When the soleplate reaches operating temperature, the thermostat light will stay
permanently on.
STEAM IRONING
1.
Set the temperature control to (
condense on the soleplate, giving you water instead of steam.
2.
Use the steam control to select the amount of steam you want.
3.
Squeeze the steam trigger to produce steam, release it to stop.
NOTE: When you first start your steam station and pull the trigger for steam ironing,
there will be a delay as your steam station pumps water from the reservoir to prime
the system. This is normal and may take 20-30 seconds. This will also happen after
refilling the reservoir.
DRY IRONING
You can dry iron by just not pressing the steam button, but if you want to make sure you
don't press it accidentally, then you should iron with an empty reservoir. You can do your
dry ironing first, then switch off, fill the reservoir and do your steam ironing.
NOTE: This product is equipped with an auto shut OFF system. When the steam
button is not press for 8 minutes or the iron rests on the base for 8 minutes, the power
turns OFF and the light on the iron starts flashing. To restart the unit turn the ON/OFF
switch to OFF and then to ON once more.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
•••
) or higher – otherwise the steam might
5
Dot setting
•
• •
• • •/max
Publicidad
Tabla de contenido
