Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DIAGRAMS
1.
Temperature control
2.
Steam trigger
3.
Steam pipe
4.
Thermostat light
5.
Reservoir
6.
Hose clip
BEFORE FIRST USE
•
Remove any labels, stickers or packaging from the iron and soleplate.
•
Before using the iron for the first time, or if it's not been used for a long time, iron a
scrap piece of cotton (an old towel is ideal) to remove any accumulated residues.
•
Don't worry if the iron smokes a bit at first, it will soon stop as the manufacturing
residues evaporate.
FILLING/REFILLING
•
Don't add anything to the water and don't use water with anything added to it.
When the water is converted to steam, chemicals, perfume, and other additives will
coat the inside of the steam chamber, shortening the life of the iron.
1.
Remove the reservoir by pulling it away from the body of the steam generator using
the grip on the front of the reservoir .
Fill the reservoir to the max mark. Do not exceed the max mark.
2.
3.
Refit the reservoir into the base unit.
PRELIMINARY SETTINGS
1.
Put the iron on top of the base unit.
2.
Put the plug into the power socket (switch the socket on, if it's switchable).
Turn the unit on by setting the on/off button to I.
3.
4.
Turn the temperature control dial to the appropriate setting for your fabric.
The thermostat light will flash until the iron has reached its desired temperature.
Once the temperature has been reached the light will remain on. This will take
30-60 seconds after you first switch on your steam station.
5.
Use the steam control on the base of the unit to select the amount
of steam you want (
7.
Plug storage
8.
Resin filter (inside reservoir)
9.
On/off button
10. Warning light/reset button
11.
Steam Control
)
4
Publicidad
Tabla de contenido
