Publicidad
-Verificar el producto, y el perfecto estado de sus componentes antes de realizar la instalación. Si se
advierte algún defecto, proceder a la reclamación antes de la instalación.
Advertencia: Es necesario, el acceso total a las partes no visibles de la bañera, con el fin de
poder realizar futuras tareas de mantenimiento.
-Noken Design baths are manufactured to the strictest standards to ensure quality performance and full customer
satisfaction at all times.
-Each and every one of our baths is assembled and tested before leaving the factory.
-All plumbing installation work should be effected in compliance with national regulations concerning plumbing
installations in buildings.
-The system must only be installed by qualified professionals.
-The installation should be in accordance with the wiring regulations in force at your country. Make sure the circuit
you are connecting to the whirltub, has been installed and protected to the installation standards in force at your
country.
-Noken Design S.A. declines all responsibility in the event of improper installation.
-This bathtub can be used by children aged from 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be made by children without supervision.
-The maximum recommended water hardness for the range of baths is 18ºTH (French degree of hardness) / 13ºe
(English degree of hardness).
-The baths are not designed to be used for seaweed, mud or seawater treatments, etc.
-There is an increased risk of falls when the surface of most baths is wet and therefore slippery. This is
particularly true when soap, shampoo, bath oils and other similar products are used. Users of baths must be
aware of this fact.
- Noken Design baths are manufactured to the strictest standards to ensure quality performance and full customer
satisfaction at all times.
- Each and every one of our baths is assembled and tested before leaving the factory.
- All plumbing installation work should be effected in compliance with national regulations concerning plumbing
installations in buildings.
- The bathtub must only be installed by trained plumbing engineers following strictly the manual guidelines.
- The installation should be in accordance with the wiring regulations in force at your country. Make sure the circuit
you are connecting to the whirltub, has been installed and protected to the installation standards in force at your
country.
-Disconnecting means must be incorporated into the fixed installation in accordance with the installation regulations
-If the power cord cable is damaged, it must be replaced by the Noken after-sales service or by similar qualified
person in order to avoid a danger
- The parts that contain active parts, except those supplied with very low safety voltage that does not exceed 12 V,
are inaccessible for a person inside the bathtub.
-The devices that are grounded must be permanently connected to a fixed electrical canalization
- The parts that include electrical components, are fixed so that they can not fall into the bathtub
- The devices should be powered by a residual current device (RCD) with a maximum residual current of 30mA
- Make an equipotential connection between the equipotential connection of the bathtub and the existing installation
according to the regulations in each country
-The recommended inlet pressure of cold / hot water must not be less than 2 bar. (200kpa).
-The recommended inlet pressure of hot / cold water must not exceed 5 bar. (500kpa)
-The new hoses supplied with the appliance must be used. Old hoses should not be used.
- Noken Design S.A. declines all responsibility in the event of improper installation.
NB: Before proceeding with the installation, check that all the parts supplied are in perfect condition. Notify the
carrier immediately if this is not the case.
3
Publicidad
