Installation Instructions; Part Numbers - Cequent Performance Products 65078 Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

License plate holder relocation

and/or modification may be

required to install hitch, see

49802 or 5443 sold separately.

Existing tow hook bolt.

(Both sides)

Fascia trim required. Obtain

vehicle owners approval before

cutting

NOTE: If front mounted license plate is present, license plate holder relocation, removal and/or modification required to

install hitch, see 49802 or 5443 sold separately.

Note: Obtain vehicle owners approval before cutting. Trim fascia for receiver tube.

Measure from the tow hook bolt center to level ground.

Subtract 3-5/8"(3.625)[92mm] from step 1. This is the distance from level ground to bottom of fascia cutout.

Mark the location of the bottom of fascia cutout on front of fascia.

Measure 3-1/4" up from the bottom of fascia cut. This is the location of the top of fascia cutout.

Locate the center of the fascia from left to right and mark 1-5/8" each side. ( 3-1/4" square)

Drill (4) 3/8" hole in corners.

Carefully cut the 3-1/4" hole from the fascia.

Die grinder or tool suitable for cutting metal may be required on GMC models.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent

entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a

vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and

SAE J684.