Care And Cleaning - HAEGER HC-WR3.007B Instrucciones De Uso

English
charged for 8-10 hours, but it shouldn't be charged for long time, or it will shorten
the operation life of the batteries.
1. Slide the ON/OFF switch downwards.
2. Insert the plug of the mains adaptor into the power jack of the hair trimmer.
3. Plug the mains adaptor into a power socket outlet.
4. The indicator light will always display red light.
5. Cut off the power after charging about 8 hours.
Notes: It is normal that the outer and transformer of electric hair clipper is slightly
heat.
O
PERATION INSTRUCTIONS
1. Your hair clipper was examined to ensure that the blades were oiled and aligned
before leaving the factory.
2. Add a few drops of oil to the blades, turn clipper on for a few seconds before
trimming and then turn off. Use a damp cloth to wipe the clipper body to avoid
that the oil spatter on people's hair.
3. Please always keep the clipper clean and usually drop oil to lubricate the blades.
R
ECOMMENDATIONS
•
We recommend that the hair should be DRY when cutting with the clipper for
better control over the amount of hair cut.
•
Use SHORT STROKES. Do not complete a whole side with one stroke.
•
Remember to comb the hair frequently as you are cutting it.
•
To cut the HAIR EVENLY, allow the clipper ADVANCE SMOOTHLY through the hair.
Do not attempt to force it.
•
It is better to cut a little than too much. Begin with the maximum cutting length
position (12 mm).
•
We recommend that you make a note of the cutting level selected each time, so
that you can repeat the same hairstyle on other occasions if you wish.
C C
ARE AND LEANING
– It is essential to switch off the unit and remove the main adaptor from the wall
socket before cleaning and oiling.
4 Instructions manual