RIDGID RT06000 Manual Del Usuario página 7

ASSEMBLY
Carry Handle Assembly
1. Locate the Carry Handle and the two (2)
#10 x 3/4" (19 mm) Pan Head Screws in
loose parts bag.
2. Position the Carry Handle on top of the
Powerhead Assembly, with the Carry
Handle Extended Flange to the rear of
the Powerhead, as shown.
3. Insert a #10 x 3/4" (19 mm) Pan Head
Screw through the hole at each end
of the Carry Handle and into the
Powerhead Assembly. Tighten securely.
Extended
Flange
SP7063.indb 7
#10 x 3/4" (19 mm)
Pan Head Screws
(2)
Carry Handle
Powerhead
Assembly
7
Inserting the Professional
Locking Hose
1. Insert the larger end of the Professional
Locking Hose into the Inlet Port.
Engage the Professional Locking Hose
Latch to the lip of the Inlet Port. The
Professional Locking Hose should
snap into place.
2. To remove the Professional Locking
Hose from the Vac, press the Release
Button on the Professional Locking
Hose and pull the Professional Locking
Hose out of the Inlet Port, as shown.
Professional
Locking Hose
Powerhead
Assembly
Vac Inlet
Release
Button
5/17/18 4:07 PM