Medisana TENS TDP Instrucciones De Manejo página 42

Application
GB
Delete defi ned
programs
36
8. With one of the controls
9. Briefl y press the button
nate and the ramp time will blink on the display
10. Set the desired ramp time (1 to 10 sec.) with one of the controls
11. Briefl y press the button
illuminate and the continuous time will blink on the display
12. Set the desired continuous time (1 to 20 sec.) with one of the controls
13. Briefl y press the button
and the relax time will blink on the display
14. With one of the controls
15. Briefl y press the button
This program has now been saved and can be used like a preset program (see
page 33 and 34).
In order to reset the self-defi ned programs to the factory default, hold the but-
ton " " with the device on for approximately 5 seconds until a long signal is
audible.
Factory settings for the programs:
TENS
Program Duration
U-01 30 min.
U-02 30 min.
EMS
Program Duration
U-01 30 min.
or , set the desired pulse width (50 to 300 μS).
"Set". The display
"Set". The display
"Set". The display
.
or , set the desired relax time (1 to 20 sec.).
"Set".
Frequency
50 Hz
1.0 Hz
Fre- Pulse
quency width
80 Hz 150 μs
"ramp." (ramp time) will illumi-
.
or
"con." (continuous time) will
.
"rel." (relax time) will illuminate
Pulse width
200 μs
100 μs
Ramp/ Continu-
drop ous time
1 sec. 8 sec.
.
or .
Relax
5 sec.