Stopping The Engine - Briggs & Stratton ELITE Serie Instrucciones De Uso

Stopping the Engine
1. Turn OFF and unplug all electrical loads from
generator pane[ receptacles. NEVER start or stop engine
with electrical devices plugged in and turned ON.
2. Let engine run at no-load for several minutes to
stabilize internal temperatures of engine and generator.
3. Turn engine off according to instructions given in the
engine owner's manual.
4. Move fuel valve to "Off' position.
RECEPTACLES
[ CAUTION
1
. NEVER attempt to power a device requiring more amperage
than generator or receptacle can supply.
. DO NOT overload the generator. See "Don't Overload
Generator".
120/240 Volt AC, 30 Amp, Locking
Receptacle
Use a NEMA LI4-30 plug with this receptacle. Connect a
4-wire cord set rated for 250Volt AC loads at 30Amps (or
greater) (Figure 6).You can use the same 4-wire cord if you
_[an to run a 120Volt load.
4-Wire Cord Set
__11
/ --\
NEMA LI4-30
Y (Hot)
(Neutral)
X (Hot)
Ground (Green)
This receptacle powers 120/240VoltAC, 60 Hz, single
phase loads requiring up to 7,200 watts of power (7.2 kW)
at 30Amps for 240Volts or two independent 120Volt
loads at 30 Amps each.The outlet is protected by
push-to-reset circuit breakers.
I 2.0Volt AC, 2.0 Amp, Duplex
Receptacles
Each duplex receptacle (Figure 7) is protected against
overload by a push-to-reset circuit breaker.
@
@
Use each receptacle to operate 120Volt AC, single-phase,
60 Hz electrical loads requiring up to 2,400 watts (2.4 kW)
at 20 Amps of current. Use cord sets that are rated for
125 Volt AC loads at 20 Amps (or greater).