Technical Data; Before Starting The Equipment - EINHELL TH-AG 2300/180 Manual De Instrucciones Original

Anleitung_TH_AG_2300_180_SPK8__ 06.08.12 15:43 Seite 27

5. Technical data

Mains voltage: 230 V ~ 50 Hz
Power input:
Idling speed:
Max. wheel diameter:
Mounting spindle thread:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 91.2 dB(A)
pA
K uncertainty
pA
L sound power level 102.2 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Surface sanding/grinding
Vibration emission value a = 10.35 m/s 2
h
K uncertainty = 1.5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
2280 W Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
7600 rpm
18 mm
Residual risks
M14 Even if you use this electric power tool in
accordance with instructions, certain residual
II / ®
risks cannot be rules out. The following hazards
3.9 kg
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
3 dB

6. Before starting the equipment

3 dB
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
6.1 Fitting the additional handle (Fig. 2)
The angle grinder must not be used without the
n
additional handle (4).
The additional handle can be secured in any of 3
n
positions (A, B, C).
Tool side Suitable for
Left (position A / as shown) Right-handed users
Right (position B) Left-handed users
Top (position C) Using cutting wheels
6.2 Setting the guard (Fig. 3)
Switch off the tool. Pull the power plug.
n
Adjust the guard (5) to protect your hands so that
n
the material being ground is directed away from
your body.
The position of the guard (5) can be adjusted to
n
any specific working conditions. Undo the clamp
handle (a) and turn the cover (5) into the
required position.
Ensure that the guard (5) correctly covers the
n
gear wheel casing.
Secure the clamp handle (a) again.
n
Ensure that the guard (5) is secure.
n
Take care that the safety device is secure.
GB
27