Technical Data - Ansmann Energy AC48 Instrucciones De Manejo

GB
OPERATING INSTRUCTIONS AC 48
USE OF THE CHARGER
plug-in charger for Nickel-Metal-Hydride and Nickel Cadmium batterypacks, not for
Lithium-Ion batterypacks. Useable for batterypacks from 4-8 cells ( 4,8 V-9,6 V ).
IMPORTANT ADJUSTEMENTS BEFORE USE
Chose the correct connector: The enclosed connectors correspond to the most
commonly used. The correct connector should fit properly using a little pressure. Do not
use extreme force to set the connector as this could damage the unit to be charged.
Set the correct polarity for the equipment to be charged: Look on the equipement or its
instruction manual for the polarity and set the coupling socket (3) to the correct polarity
(see drawing no.1). Please pay attention to the right polarity. The charger or the battery
pack could be damaged if you want to charge with the wrong polarity.
OPERATION
Plug the power plug into a convenient mains socket. After connecting the charger with
the batterypack the charging indicator (2) signalize the charging. The charging doesn´t
stop automatically. Please take a look to the charging table (4) for the right charging
time.
Calculation of the charging time: Look for the charging time/100 mAh of your battery
pack. Multiply this charging time with the capacity of the battery pack. Example: battery
pack 6 cells (7,2 V) with 700 mAh • charging time/100 mAh: 35 min • 7 x 35 min =
approx. 245 min (5,1 h) charging time
ATTENTION
The charger are for indoor use only. The charger should be disconnected from the
mains when not in use. Do not plug in the charger in case of damaged cabinet or power
plug. Never open the charger.

TECHNICAL DATA

Pri.: 230 V ~ 50 Hz • Sec.: 4,8 – 9,6 V (350 – 150 mA)