Important Safety Instructions - Epson L300 Manual Del Usuario

Important Safety Instructions

Before using your Epson
■
Be sure to follow all warnings and instructions marked on the product.
■
Use only the type of power source indicated on the product's label.
■
Make sure the AC power cord meets the relevant local safety standards.
■
Use only the power cord that comes with the product. Use of another cord may cause fires or
shock. Do not use the cord with any other equipment.
■
Place the product near a wall outlet where the plug can be easily unplugged.
■
Avoid plugging the product into an outlet on the same circuit as a photocopier or air
conditioning system that regularly switches on and off, or on an outlet controlled by a wall
switch or timer.
■
Do not let the power cord become damaged or frayed. Do not place objects on top of the cord,
do not step on or run over the cord, and keep the cord straight at the ends.
■
If you use an extension cord with the product, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the
total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's
ampere rating.
■
Always turn off the product using the
flashing before unplugging the product or cutting off power to the electrical outlet.
■
If you will not be using the product for a long period, unplug the power cord from the electrical
outlet.
■
Place the product on a flat, stable surface that extends beyond its base in all directions. It will
not operate properly if it is tilted or at an angle.
■
Leave enough space behind the product for the cable(s), above the product so that you can fully
raise the printer cover, and in front of the product for the paper to be fully ejected. Make sure
the back of the product is at least 4 inches (10 cm) away from the wall.
■
Avoid locations that are subject to high temperature or humidity, rapid changes in temperature
or humidity, shocks or vibrations, water, dust or dirt.
■
Do not place or store the product outdoors.
■
Do not place the product near excessive heat sources, strong light, or in direct sunlight.
■
Leave enough room around the product for sufficient ventilation. Do not block or cover
openings in the case or insert objects through the slots in the product.
■
Keep the product away from potential sources of electromagnetic interference, such as
loudspeakers or the base units of cordless telephones.
■
When connecting the product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a
connector in the wrong orientation may damage both devices connected by the cable.
■
Do not touch the flat white cable and ink tubes inside the product.
■
Do not move the print head by hand; this may damage the product.
product, read and follow these safety instructions.
®
P power button, and wait until the P power light stops
Important Safety Instructions
9