Important Safety Instructions - Epson Stylus TX110 Manual De Usario

Important Safety Instructions

Before using your printer, read and follow these safety instructions:
■
Be sure to follow all warnings and instructions marked on the printer.
■
Use only the type of power source indicated on the printer label.
■
Use only the power cord that comes with the printer. Use of another cord may result
in fire or electric shock. Do not use the cord with any other equipment.
■
Place the printer near a wall outlet where the plug can be easily unplugged.
■
If you won't be using the printer for a long period, unplug the power cord from the
electrical outlet.
■
Always turn the printer off using the
the
P Encender/Ligar
cutting off power to the electrical outlet.
■
Avoid plugging the printer into an outlet on the same circuit as a photocopier or air
control system that regularly switches on and off, or an outlet controlled by a wall
switch or timer.
■
Do not let the power cord become damaged or frayed.
■
If you use an extension cord with the printer, make sure the total ampere rating of the
devices plugged into the extension cord does not exceed the cord's ampere rating.
Also, make sure the total ampere rating of all devices plugged into the wall outlet does
not exceed the wall outlet's ampere rating.
■
Avoid locations that are subject to rapid changes in heat or humidity, shocks or
vibrations, or dust.
■
Leave enough room around the printer for sufficient ventilation. Do not block or
cover openings in the printer case or insert objects through the slots.
■
Do not place or store the printer near a radiator or heating vent, in a dusty or moist
environment, in direct sunlight, or outdoors.
■
Keep your printer away from potential sources of electromagnetic interference, such
as loudspeakers or cordless telephone base units.
■
Do not use aerosol products that contain flammable gases inside or around the
printer. Doing so may cause fire.
■
Place the printer on a flat, stable surface that extends beyond its base in all directions.
It will not operate properly if it is tilted or at angle.
■
Do not open the scanner section while the printer is copying, printing or scanning.
■
Do not touch the white flat cable inside the printer, and be careful not to trap your
fingers when closing the scanner.
14
Important Safety Instructions
P Encender/Ligar
(On) light stops flashing before unplugging the printer or
(On) button, and wait until