Atlantic SOLWPL1 Manual Del Producto página 2

Introduction
Thank you for purchasing Atlantic Warm White Pond Lights. Atlantic's Pond Lights feature high
impact cases and silicone gaskets for dependability and longevity. Whether underwater or in
open air applications, Pond Lights impart a soothing, warming glow after the sun goes down.
Available in single light or triple light kits with included removable photo cell and transformer.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any conditions other than those for which it is
specified. Failure to observe these precautions can lead to electrical shock, product failure,
or other problems.
• Follow all electrical codes when installing Atlantic Lighting.
• To reduce the risk of electrical shock, connect transformer to a 120 volt receptacle protected
by a ground fault circuit interrupter (GFCI).
• Warm White lights connect via a 2-wire quick-connect plug that is gasketed for
outdoor use. Quick-connect plugs are not waterproof and should not be submersed.
• Always use dielectric grease on all connections and verify that the lens ring is tightly secured
before submersing the fixture.
• The cord is flat low voltage wire and can be cut and spliced as needed. ONLY THE FLAT
WIRE CAN BE CUT. Atlantic Warm White lights can be connected to an existing 12 volt AC
lighting system by cutting and stripping the flat low voltage wire.
Installation
Pond Lights offer two different mounting options for your convenience:
• Adjustable stand: for placement on rock ledges, under waterfalls or for
highlighting streambeds
• Nestled: without the stand amongst the pond stones
Proper light placement is important for every project. Whenever possible, lights should be
positioned facing away from the viewing area to minimize hot spots. When camouflaging the
light cord with rocks and gravel, always leave enough slack in the cord so that the fixture can be
raised above water level for servicing.
Warm White Pond Lights
Warm White Pond Lights come with a photocell that will turn the lights on at dusk and off after
6 hours. The photocell is equipped with a memory function. In case the photocell gets covered,
the photocell will repeat its last 24 hour cycle indefinitely, until the photocell is uncovered.
Maintenance
Replacement LED diode assemblies are available for Pond Lights. Loosen clear plastic lens and
remove diode assembly. Install the new diode assembly and align gasket. Tighten clear plastic
lens. Ensure that all components are installed correctly after servicing. Ensure that the clear
plastic lens is tightly secured before submersing the fixture.
Light
Body
2
All manuals and user guides at all-guides.com
Silicone Gasket
LED Diode
Assembly
Clear Plastic Lens