Care & Cleaning - LG LSWD305ST Manual De Instrucciones

CARE & CLEANING
Changing the Oven Light
The oven light is a standard 10-watt halogen bulb
for ovens.
To replace lamps located on the side wall:
• Make sure oven and bulb are cool.
1. Unplug oven or disconnect power.
2. Remove oven racks.
3. Slide a flat blade screwdriver between the
housing and the glass light cover.
4. Support the glass light cover with two fingers to
prevent the cover from falling to the bottom of
the oven.
5. Gently twist the screwdriver blade to loosen the
glass light cover.
6. Remove bulb from socket.
7. Replace bulb, replace light cover by snapping
back into place.
8. Plug in oven or reconnect power.
Glass Light Cover
Flat blade screwdriver
To replace a lamp located on the top wall:
• Make sure oven and bulb are cool.
1. Unplug oven or disconnect power.
2. Remove oven racks.
3. Slide a flat blade screwdriver between the
housing and the glass light cover.
4. Support the glass light cover with two fingers to
prevent the cover from falling to the bottom of
the oven.
5. Gently twist the screwdriver blade to loosen the
glass light cover.
6. Remove bulb from socket.
7. Replace bulb, replace light cover by snapping
back into place and push the clip to hold the
glass light cover tightly.
8. Plug in oven or reconnect power.
Glass Light Cover
Flat Blade screwdriver
WARNING
• Before replacing your oven light bulb,
DISCONNECT the electrical power to the oven at
the main fuse or circuit breaker panel.
- Failure to do so can result in severe personal injury,
death, or electrical shock.
• Make sure oven and bulb are cool.
Housing
Painted Parts and Trim
For general cleaning, use a cloth with hot and
soapy water. For more difficult soils and built-up
grease, apply a liquid detergent directly onto the
soil. Leave on soil for 30 to 60 minutes. Rinse with
a damp cloth and dry. DO NOT use abrasive
cleaners on any of these materials; they can
scratch the parts and trim.
Stainless Steel Surfaces
Do not use a steel-wool pad, it will scratch the surface.
1. Place a small amount of Stainless Steel Appliance
Cleaner or polish on a damp cloth or damp paper
towel.
2. Clean a small area, rubbing with the grain of the
stainless steel if applicable.
3. Dry and buff with a clean, dry paper towel or soft
cloth.
4. Repeat as necessary.
NOTE: If a mineral oil-based stainless steel
appliance cleaner has been used before to clean
the appliance, wash the surface with a mild soap
and water prior to using the Stainless Steel
Appliance Cleaner or polish.
Clip Housing
33