Publicidad
Idiomas disponibles
Idiomas disponibles
SECURE CRADLES TO MAST.
Insert bolt and
washer (right
to left) into
rounded
depression on
underside of cradle.
POSITIONING CRADLES: You may want to
adjust cradles once bikes are loaded.
LOAD YOUR BIKE.
Nest bike's top tube into first
cradle.
FOR U-LOCK USERS:
THE "U" MUST
Release safety hook
STRADDLE FIRST BIKE'S
by pulling outward
TUBE.
on untethered end.
NOTE:
With first bike locked, all
other bikes are secure.
Use a flathead screwdriver.
Attach nut...
TIGHTEN EACH
CRADLE CAREFULLY.
Load bikes in opposite
directions.
You may want to loosen
cradles and adjust bike
spacing.
Don't forget to tighten
the bolts again!
TO FOLD MAST DOWN AND ACCESS
REAR: Unload bikes.
Slide pin out while supporting
mast.
The last cradle
must be behind
metal rivet.
Tighten screw!
HOOK STRAPS OVER BIKE'S TUBE.
Be sure straps are secured
onto cradle hooks.
Don't forget to
replace pin AND
secure safety
hook.
ATTACH CRADLE STRAPS.
Be sure strap is hooked
onto cradle.
CHECK CRADLES!
Grab close to bar with
both hands.
Straps can be
routed between
TIGHTEN IF THERE IS
cables and tube.
MOVEMENT.
MAINTENANCE
Use non-water soluble lubricant
on moving metal parts.
Use a soft cloth with water and
mild detergent to clean plastic parts.
BEFORE DRIVING AWAY,
read cautions
on first page.
Publicidad
