Use - Casselin CFB16 Manual De Instrucciones

• The device must be connected properly and comply with regulations.
WARNING
By operating the apparatus may reach high temperatures. To avoid burns and accidents, do not use the
machine malfunction and do not use spare parts that do not origins.
ELECTRICAL HAZARD
Risk from electrical current!
In case of improper installation, the device can be dangerous and cause injury. Before installation, check the
power system data. Connect the device only when there is compliance. The unit should be unpacked and
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The unit must be completely removed from its packaging. All guards must be completely removed.
Place the machine upright on a solid, flat surface. Never place the fryer donut on a flammable surface.
Do not install this device near open fires or other heating appliances.
The device must be plugged directly into a wall outlet. Using a power strip will crack up the device.
Electrical connection: Installation and commissioning unit into operation must be performed by personnel
with the skills necessary for this purpose and conducted in compliance with the applicable standards of
accident prevention. Be sure to make the connection in compliance with the data on the data label. The
power outlets must be near the appliance and be easily accessible. If this equipment is wired directly to the
power supply, it is necessary to incorporate a power cut-off means with separation of the contacts at least 3
mm for all poles.
The device must be placed with a 10 cm safety distance with the wall.
Verify the absence of water in the oil pan then pour oil into the tray. Two pins are included in the oil pan.
The minimum and maximum amounts are to be observed. It is recommended to use quality oil, less
saturated fat vegetable oils are recommended. (When using solid shortening, have it always melt before
adding it to the frypot). Change the oil regularly.
USE
Press the switch, and then turn the thermostat to the desired temperature between 90 ° C and 180 ° C. The
green LED turns on and then turns off after reaching the desired temperature.
Once the frying performed, lift the basket through the lateral handles and drain frying.
With its thermostat when the temperature drops, the device starts to be heated to maintain the oil at the
desired temperature; the temperature indicator comes on again automatically.
At the end of the use, press the On / Off switch, then unplug the appliance.
After cooling of the fryer and oil, drain in compliance with environmental protection rules.
WARNING
During heavy use, the oil can heat and ignite, think cool oil and change it regularly to avoid this. This fryer
may tip over and cause injury if it is not fixed.
The service apparatus may reach high temperatures. The outer sides of the fryer surface can be hot. The
device should not be touched or moved during or immediately after use. The hands and face are to be
protected from possible fat splashes.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
FR