Recording From Cds; Recording Your Own Programme; Recording A Cd By Specifying Tape Length (Time Edit) (Cdp-Xe520 Only) - Sony CDP-XE520 Manual De Instrucciones

Recording From CDs

Recording Your Own
Programme
You can record the programme you've created on a
tape, DAT or MD. The programme can contain up to 24
tracks.
By inserting a pause during programming, you can
divide the programme into two for recording on both
sides of a tape.
• CDP-XE520
PLAY MODE
• CDP-XE320 and CDP-XE220
PLAY MODE
1
Create your programme (for side A when
recording on a tape) while checking the total
playing time indicated in the display.
Follow Steps 1 to 4 in "Creating a programme on
the player" on page 12 or Steps 1 and 2 in
"Creating a programme using the remote" on page
13.
The "TAPE A" (or
CDP-XE320 and CDP-XE220) appears in the
display.
2
When you record on both sides of the tape, press
P to insert a pause.
The "P" and "TAPE B" (or
CDP-XE320 and CDP-XE220) appear in the display
and the playing time is reset to "0.00."
When you record on one side of the tape or on a
DAT or MD, skip this step and go to Step 4.
A pause is counted as one track
You can programme up to 23 tracks when you insert a
pause.
3
Repeat Step 1 to create the programme for side B.
GB
14
≠ AMS ±
· P
≠ AMS ±
· P
A
indication for the
A B
indication for the
4
Start recording on the deck and then press · on
the player.
When you record on both sides of the tape, the player
pauses at the end of the programme for side A.
5
When you record on side B, reverse the tape and
press · or P on the player to resume playing.
To check and change your programme
See page 13.
A
The "TAPE A" (or indication for the CDP-XE320
and CDP-XE220) appears while checking the
programme for side A and "TAPE B" (or
for the CDP-XE320 and CDP-XE220) appears while
checking the programme for side B.
When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
Recording a CD by Specifying
Tape Length (Time Edit)
(CDP-XE520 only)
You can have the player create a programme that will
match the length of the tape. In this feature, the player
creates a programme basically keeping the original
order of the disc. However, the player may change the
last track of each side to match the recording time to
the tape length.
i.e. Side A: track number
Side B: track number
The programme may contain up to 24 tracks (a pause
inserted between tracks is counted as one track).
Note that tracks numbered over 24 cannot be
programmed in this feature.
EDIT/TIME FADE
B
indication
1n2n3n4n8
5n6n7n9n10
0/)
· P